Issue with decompose function and visibility.

[Nicko]

In the last month or so when I try to decompose any element of the wave, impulse or correction, the minor degree isn't shown along the wave I want to break up but all the numbers/letters are stacked on top of each other at the end point of the wave I'm decomposing.
Secondly, but not a real issue, is there any option for the waves to be viewed only on the current time frame and below? I.e. If I'm labelling a chart on the daly, I only want to see those labels on daly, 4hours, 1hour etc etc but not on weekly. Is there an option that allows me that by default instead of right click>visibility etc etc?

Thank you support team.

P.S. Great idea this of the forum, well done.

 

[MotiveWave_Jason]

Hi Nicko,

Could you please send an email to support@motivewave.com with some screenshots of the issue you're describing. Please also include a backup of your workspace.

Is this for Auto Analyze or manual placement of components? You are able to set defaults on certain waves/degrees and their bar size visibility. Would this accomplish what you need? You can include more detail in your email to support and we can go from there.

Thank you.

 

[...]

Hi Nicko,

Could you please send an email to support@motivewave.com with some screenshots of the issue you're describing. Please also include a backup of your workspace.

Is this for Auto Analyze or manual placement of components? You are able to set defaults on certain waves/degrees and their bar size visibility. Would this accomplish what you need? You can include more detail in your email to support and we can go from there.

Thank you.

Auto Analyze almost always gives my an impossible count where the count is straight up and down or the 5 is where the 3 is

 

[Nicko]

Hi Nicko,

Could you please send an email to support@motivewave.com with some screenshots of the issue you're describing. Please also include a backup of your workspace.

Is this for Auto Analyze or manual placement of components? You are able to set defaults on certain waves/degrees and their bar size visibility. Would this accomplish what you need? You can include more detail in your email to support and we can go from there.

Thank you.

Hey Jason,
I'll send you an email but no, it's not on Auto Analyse, but manual. When it happens again I'll take a screen shot and send it over.

Thanks

 

[Dojidog]

Hey Jason,
I'll send you an email but no, it's not on Auto Analyse, but manual. When it happens again I'll take a screen shot and send it over.

Thanks

Have had the same issue with auto decompose. All the waves/labels stack up on the decomposed wave end point. Have to drag one point off so I can delete the mess. At that point I bring what I want off the components selection. Problem is it is an inconsistent error. Hard to duplicate